Filter
Top Products
31
To customize the Dual Digital page:
1. Use the
UP and DOWN keys to scroll the Dual Digital page on to the
main display.
2. Press
MENU, select CUSTOMIZE and press MENU.
3. The position menu will appear with two options: Top Data or Bottom
Data. Select
TOP DATA and press MENU, which will open the Data menu.
4. Highlight the data type you want to display and press
MENU. This
will take you back to the main display, where the data type you
selected will be displayed in the digital box at the top of the page.
5. Repeat steps 1 and 2, then select
BOT DATA from the position menu
and press
MENU.
6. Highlight the data type you want to display and press
MENU. This
will take you back to the main display, where the data type you
selected will be displayed in the digital box at the bottom of the page.
NOTE:
If a page is customized to show information from a device that is
not connected to the NMEA 2000 network, the data boxes on the
gauge will flash. This indicates the device is not sending data to the
network. This could occur for a variety of reasons, depending on the
device type. If it is a GPS sensor, the GPS unit probably has not
locked on to a satellite yet. If you try to display data from an
unconfigured EP, the gauge will flash.
Gauge
The Gauge page is an analog gauge that can be customized to display
the following data types: WTR:S (Water Speed), GND:S (Ground
Speed), Tach (Tachometer), ALR:V (Alternate Voltage), BAT:V (Battery
Voltage), ENG:T (Engine Temperature), WTR:P (Water Pressure),
ENG:O:P (Engine Oil Pressure), FUL:P (Fuel Pressure) BST:P (Boost
Pressure), TRN:O:P (Transmission Oil Pressure), ATM:P (Atmospheric
Pressure), Temp (Temperature) and Fluid Lev (Fluid Level).
To Customize the Gauge Page:
1. Use the
UP and DOWN keys to scroll the gauge page on to the main
display.
2. Press
MENU, select CUSTOMIZE and press MENU, which will open the
Data menu.
3. Highlight the data type you want to display and press
MENU. This
will take you back to the main display, where the data you selected will
be displayed on an analog gauge.