Filter
Top Products
61
Appendix
Below are basic definitions of categories, category variations and
abbreviations you may see when customizing LMF-200 page displays.
ALR:V (Alternator Voltage): shows voltage output from the alternator.
ATM:P (Atmospheric Pressure): displays atmospheric pressure
readings.
BAT:V (Battery Voltage): shows voltage output from battery.
BlkW (Black Water): a fluid level configuration used to monitor the
toilet holding tank.
BST:P (Boost Pressure): using PSI, displays boost pressure readings for
a supercharged engine.
CEN: (Center Engine): the center engine will be in the center of the
vessel.
Depth: displays depth of the water in vessel’s location.
ECO (Fuel Economy): uses fuel flow and speed (Ground or Water)
information to calculate the real time economical performance of up to
three engines.
ENG: Hr (Total Engine Hours): displays tally of the total hours the
engine has been used since gauge was installed.
ENG:L (Engine Load): displays in percent, how hard an engine is
working.
ENG:O:P (Engine Oil Pressure): shows engine oil pressure readings.
ENG:T (Engine Temperature): displays engine temperature readings.
Fluid Lev (Fluid Level): displays fluid level readings from several types
of tanks, including fuel, blackwater, fresh water, live well, oil and
waste water (gray water) tanks.
FrW Tnk: (Freshwater Tank): a fluid level configuration used to
monitor the freshwater tank.
FUL:F (Fuel Flow): shows how much fuel has passed through fuel flow
FUL:P (Fuel Pressure): displays fuel pressure readings.
FUL: Rm (Fuel Remaining): displays amount of fuel left in fuel tanks.
GND:S (Ground Speed): displays vessel’s speed.
LW Tnk: (Live Well Tank): a fluid level configuration used to monitor
the live well.
RNG (Fuel Range): uses fuel economy and fuel remaining figures to
calculate how far a vessel can travel before running out of fuel.
Tach (Tachometer): can display engine RPM readings for up to three
engines.