Filter
Top Products
22
Timeout
You will notice there is no exit key in the LMF-200. Its menus time out,
meaning they will be automatically cleared from the screen after a
preset amount of time. The timeout duration will begin after the last
button is pushed.
1. To change the Timeout settings, press
MENU, use the UP and DOWN
keys to select
SYSTEM SETUP and press MENU.
2. Highlight
TIMEOUT and press MENU. The Timeout menu will open with
four options: 3, 5, 10 and 15 seconds.
3. Choose the desired timeout setting and press
MENU. You will be
taken back to the main display.
Eng (Engine)/Tank
The Engine/Tank configuration menu displays the number of engines
and fuel tanks on the vessel as well as fuel tank capacity. You selected
your engine-tank configuration during Boat Setup. If the selected
configuration is incorrect, you can return to Boat Setup by resetting the
configuration from the Engine/Tank Configuration menu.
To reset Eng/Tank configuration:
1. Press
MENU, use the UP an DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
ENG/TANK and press MENU. The Engine-Tank configuration
page will appear.
3. Press
MENU and the following message will appear: Press Menu to
reset Eng/Tank. Press
MENU. You will be taken to the Boat Setup
screen.
Reset
The Reset command allows you to switch the LMF-200 back to factory
default settings.
To reset values:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
RESET and press MENU. The following message will appear:
Hit Menu to Rst All values. Press
MENU. You will be taken back to the
main display.
WARNING:
Resetting values is a hard reset. All LMF-200 settings
will be set back to factory defaults. Resetting values,
however, does not affect engine/tank configuration or
the calibration and configuration settings of devices on
the bus.