Filter
Top Products
56
6. Compare the amount of fuel you added when you filled up the tank
with to the Fuel Used figure in the LMF-200. If the difference between
these two numbers is greater than 3 percent, you need to recalibrate
the unit.
7. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
8. Highlight
FUEL MNGR and press MENU. Select REFILL T. and press MENU.
The Select Tank menu will open with three options: Port, Center and
Starboard. Select the tank you refilled and press
MENU.
9. The Recalibration (The Recal?) menu will appear with two options:
Yes and No. Select
YES and press MENU.
10. The Filled Quantity window will appear. Use the
UP and DOWN
keys to input the amount of fuel you added to the tank and press
MENU.
11. Repeat these steps for each engine interface you want to calibrate.
NOTE:
The LMF-400 will not let you input an amount of fuel greater than
the fuel used figure.
Reset Calibration
The Reset Calibration command allows you to reset engine interface
calibration back to default settings.
To Reset Calibration:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. Select the engine interface you
want to reset and press
MENU.
3. Select
RST CAL from the engine interface menu and press MENU. The
following message will appear: Hit Menu to Rst the Cal.
4. Press
MENU to set calibration back to factory default settings. To
recalibrate the interface, follow the steps in the previous segment
regarding engine interface calibration.
Partial Fill
You will use the Partial Fill option each time you add fuel but do not
fill up the tank.
To use Partial Fill:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
FUEL MNGR and press MENU. Select PART FILL. and press
MENU. The Select Tank menu will open with three options: Port, Center
and Starboard. Select the tank you refilled and press
MENU. The Fuel
Quantity window will appear.