Filter
Top Products
43
Level Warning:
A Level Warning alerts you when the fluid level rises above or falls
below a preset percentage of tank capacity. The Level Warning menu
has two options: Low Level and High Level. A low level warning is used
for fluid types like fuel, oil and freshwater, whereas a high level
warning is best suited for black water and Waste Water (Gray Water).
To set a Level Warning:
1. Press
MENU, select SYSTEM SETUP and press MENU. Highlight B. DEVICES
and press
MENU.
2. Select a configured fluid level and press
MENU, which will open the
Configuration Options menu. Highlight
LEV WRNG and press MENU.
3. The Select Level menu will appear with two options: Low Level and
High Level.
NOTE:
If you configure a tank for fuel, you should choose a
LOW LEVEL
warning, which will warn you when the fuel level drops below a
preset percentage of the tank's capacity. A Low Level alarm will
also work best for Fresh Water and Oil configurations. When a
tank is configured for Black Water or Waste Water, the Level
Warning should be set to the High Level. If, for example, you set
the High Level warning to 3 Quarters of a tank (75 percent), you
would be alerted before the tank's capacity had been exceeded,
allowing you to empty the tank before it fills up.
4. Highlight the desired level and press
MENU. The Level Percentage
dialog box will appear. It will be set to Off by default.
5. Use the
UP and DOWN keys to set the level warning to a desired
percentage of tank capacity and press
MENU. You will be taken back to
the Bus Devices list.
Reset
The Reset command will reset all values for a device, including
configuration and calibration settings.
To execute Reset command:
1. Press
MENU, select SYSTEM SETUP and press MENU. Highlight B. DEVICES
and press
MENU.
2. Select a configured fluid level and press
MENU, which will open the
Configuration Options menu.
3. Highlight
RESET and press MENU. The following message will appear:
Hit Menu to Rst Values.