Lowrance electronic LMF-200 Marine Instruments User Manual


 
39
2. Highlight
B. DEVICES and press MENU. After a few moments, the Bus
Devices list will appear, showing all LowranceNet devices detected on
the network.
3. Select the desired fuel flow and press
MENU. Highlight RESET, press
MENU and a message will be displayed: Hit Menu to Rst Values.
4. Press
MENU to reset the fuel flow values to default settings.
NOTE:
By resetting values from the configuration menu, ONLY the device
selected from the Bus Devices list will be set back to its defaults.
When you Reset Values, the calibration and configuration settings
of the device are set back to factory defaults.
EP-15 Fluid Level Configuration
The LMF-200 can be configured with up to three tanks for each fluid
level type, which includes Fuel, Fresh Water, Oil, Black Water, Waste
Water (Gray Water) and Live Well.
On the Bus Devices list, the fuel tanks will be displayed as F. Tnk (P)
— Port, F. Tnk (C)
— Center and F Tnk (S) — Starboard. If you have
one tank it will be shown as Fuel Tank.
Other tanks will be displayed as BlkW Tnk (Blackwater), FrW Tnk
(Freshwater), O. Tnk (Oil), LW Tnk (Live Well) and WtW Tnk (Waste
Water/Gray Water). If you have more than one of particular tank type,
it will be followed by a tank number like the following examples: FrW
Tnk1, BlkW Tnk2, LW Tnk3, etc. A fluid level configured for oil will be
shown as O. Tnk (P), O. Tnk (C) or O. Tnk (S).
NOTE:
The Fuel Remaining Source must be set to fluid level for the unit to
correctly display fuel level information. It is set to Fuel Flow by
default.
Fluid Level menu
The Fluid Level menu contains the following features: Configure,
Unconfigure, Reconfigure, Level Warning, Calibrate, Reset Cal and
Reset Values. Calibration and Reset Calibration will be addressed in
the calibration portion of this section.
Caution
If you configure your fluid level for fuel, you will NOT be able to
get a fuel range reading. Fuel Range will NOT be calculated
with a fluid level sensor. It will only be calculated with an
engine interface, EP-10 Fuel Flow or EP-50 Storage Device.