Filter
Top Products
45
6. Select the desired engine and press
MENU. You will be taken back to
the Bus Devices list where the engine interface will be shown with its
new configuration.
NOTE:
If the engine interface you just configured is not shown on the Bus
Devices the list, you will have to refresh the list. Let the Bus
Devices list time out, then access it again
.
To unconfigure a Suzuki Engine Interface:
The unconfigure command (Unset Engine) allows you to set a Suzuki
Engine Interface back to its original unconfigured status.
Unconfiguring an interface also will allow you to change the engine
model selected during configuration.
Unset Engine:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES (Bus.Devices) and press MENU. The Bus Devices
list will appear.
3. Select the engine Interface you want to unconfigure and press
MENU.
4. Highlight
UNSET ENGINE and press MENU which will launch the
following message: Hit Menu to Unset Dev Name.
5.
Press MENU and you will be taken back to the Bus Devices list.
To reconfigure a Suzuki Engine Interface:
The Change Engine command is used to switch the current
configuration of a Suzuki Engine Interface with the configuration from
a different engine. Change Engine, however, will only appear on your
LMF-200 menu if you are using an engine-tank configuration that
includes multiple engines. If all engine interfaces on your vessel are
configured, you will have to unconfigure an interface to free up its
configuration name (Port, Center, Starboard).
If all three engine interfaces are configured, which means there is no
name configuration available, follow the first set of instructions. If the
desired configuration name is available, follow the second set of
instructions.
Change Engine (Active only with multiple-engine setting)
The steps below show how to switch the configuration name of an
engine interface from the Port engine to the Starboard engine.