Filter
Top Products
35
4. Select
UNCONFIG and press MENU. The following message will appear:
Hit Menu to Unset Device Name.
5. Press
MENU to unconfigure the sensor and be directed back to the
Bus Devices list, where the temp you unconfigured (Water Temp) will
be listed as Uncfg Temp.
6. Highlight
OUT T (Outside Temp) and press MENU. The configuration
options menu will appear.
7. Select
RECONFIG and press MENU to open the Selecting Temp menu.
Highlight
WATER and press MENU. You will be taken back to the Bus
Devices list.
8. Highlight
UNCFG TEMP and press MENU. The following message will
appear: Hit Menu to Cfg Temp Sns.
9. Press
MENU to be taken to the Selecting Temp menu. Choose OUTSIDE
and press
MENU. You will be taken back to the Bus Devices list, where
the two sensor will be listed with their new configurations.
If desired configuration name available:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU, which will open the Bus Devices
list.
3. Highlight
WTR TEMP on the Bus Devices list and press MENU, which
will launch the Configuration Options menu.
4. Select
RECONFIG and press MENU to open the Selecting Temp menu.
Highlight
OUTSIDE and press MENU. You will be taken back to the Bus
Devices list, where the temp will now be shown as Out T. (Outside
Temp).
EP-10 Fuel Flow Configuration
The LMF-200 can support up to three engines with one fuel flow sensor
for each engine. If you have one configured fuel flow, it will be
displayed as Eng FFlow. For a three-engine system, the fuel flows will
be displayed as Port FFlow (Port Fuel Flow), Cen FFlow (Center Fuel
Flow) and Stbd FFlow (Starboard Fuel Flow).
Each fuel flow has an internal menu with the following options: Unset
Engine, Change Engine (multiple engines only), Fuel Warning, Reset
and Reset Calibration. We will address Reset Calibration in the
calibration portion of this section.
NOTE:
If, after configuring, unconfiguring or reconfiguring a fuel flow, it is
not shown on the Bus Devices list, you will have to refresh the Bus