Filter
Top Products
3
Section 2: Installation
Preparation
When installed, the gauge will cover an area on the dash 2-3/8" (60.3
mm) in diameter. To mount the unit, first make sure there is at least 2-
3/4" (70 mm) from the front of the dash to any obstruction behind the
dash. The maximum usable dash thickness is 1-1/8" (28.5 mm). Also, be
sure there is room to route the network and buzzer cables. The
following figure shows gauge dimensions.
Dash installation, cross-section view.
Caution:
You should read over the entire installation section before
drilling any holes in your vessel!
Recommended Tools and Supplies
Recommended tools for this job include: hole saw, 2 1/8" (54 mm) hole
saw bit, drill, 1/8" (3 mm) drill bit (for starter hole).
Other supplies are not included, unless otherwise indicated. If you need
to route the gauge's network cable connector through a bulkhead, you
will need a drill and a 3/4" drill bit.
If the dash does not have a standard 2-1/8" (54 mm) hole, you will need
a drill or saw to make the hole. Carefully measure the dash thickness
and the hole area before cutting or drilling.
2-3/4"
(70 mm)
2-3/8"
(60.3 mm)
Gasket
Threaded mounting collar
Dash
Cables