Filter
Top Products
4-43
Programming
Lists of Commands
Lists of Commands
Table 4-7. Programming Commands (1 of 4)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
Common Commands
*CLS Clears all event registers and the error queue.
*ESE Sets the bits in the standard-event status enable register
*ESR? Queries value standard-event status register.
*IDN? Queries instrument model number and firmware version.
*OPC Sets operation complete bit of the standard-event status register
*RCL Recalls a saved instrument state.
*RST Resets instrument.
*SAV Saves an instrument state.
*SRE Sets bits in service-request enable register
*STB Queries value of status byte
*TRG Triggers acquisition of measurement data.
*TST? Performs an instrument self test
*WAI Causes instrument to finish processing current command before
continuing.
Measurement Instructions
:CONFigure Configures instrument for wavelength, wavenumber, frequency,
power, and coherence length measurements.
I
:FETCh Queries wavelength, wavenumber, frequency, power, and
coherence length measurements that have already been
captured.
I
:MEASure Configures, measures, and queries wavelength, wavenumber,
frequency, power, and coherence length measurements.
I
:READ Measures and queries wavelength, wavenumber, frequency,
power, and coherence length measurements.
I