Filter
Top Products
5-64
Programming Commands
CONFigure Measurement Instruction
CONFigure Measurement Instruction
For information on the CONFigure measurement instruction, refer to “Mea-
surement Instructions” on page 5-15.
DISPlay Subsystem
The commands in this subsystem have the following command hierarchy:
:DISPlay
:MARKer:
:MAXimum
:LEFT
:NEXT
:PREVious
:RIGHt
[:WINDow]
:GRAPhics
:STATe
Note
Only one STATe command can be turned on at any one time. Attempting to turn more
than one state on at a time results in a “–221 Settings Conflict” error. Refer to “Measure
delta, drift, and signal-to-noise” on page 4-14 for additional information on selecting
measurements.