Filter
Top Products
5-81
Programming Commands
SYSTem Subsystem
*SRE
*STB?/qonly/
*TRG/nquery/
*TST?/qonly/
*WAI/nquery/
PRESet
Performs the equivalent of pressing the front-panel
PRESET
key.
Syntax
:SYSTem:PRESet
Attribute
Summary
Preset
State: none
*RST State: none
SCPI Compliance: standard
Command Only
Description
The instrument state is set according to the settings shown in the following
table.
Table 5-8. Instrument Conditions (1 of 2)
Item
Settings after Preset
Key Pressed
Settings after Power
Turned On
Display mode single wavelength
last state
a
Wavelength range limiting on last state
Start wavelength 1200 nm last state
Stop wavelength 1650 nm last state
Graphical display off off
Measurement acquisition continuous last state
Wavelength calibration vacuum last state
Elevation correction value not affected last state
Wavelength units nm last state
Amplitude units dBm last state