Filter
Top Products
Index-2
Index
adapters, 1-22
cabinet, vii, 1-2
fiber-optic connections, 1-13, 1-21
non-lensed connectors, 1-21
CLEAR softkey, 3-10
CLENgth? programming command, 5-25
*CLS, 4-21, 5-3
CM –1 softkey, 2-14
Cmd_opc subroutine, 4-29
COH LEN softkey, 3-12
coherence length, iii, 3-12, 7-8
colon, 4-25
commands
combining, 4-24
common, 4-23
measurement instructions, 4-23
non sequential, 4-12, 5-29, 5-33, 5-35, 5-36,
5-37, 5-38, 5-39, 5-40, 5-41, 5-42, 5-71,
5-85, 5-86
standard SCPI, 4-23
termination, 4-27
common commands
*CLS (clear status), 5-3
*ESE (event status enable), 4-28, 5-3
*ESR (event status register), 5-5
*IDN (identification number), 4-29, 5-6
*OPC (operation complete), 4-29, 5-6
*RST (reset), 4-29, 5-8
*SRE (service request enable), 5-10
*STB (status byte), 5-12
*TRG (trigger), 5-13
*TST (test), 5-13
*WAI (wait), 5-14
definition, 4-23
sending, 4-25
compressed dust remover, 1-20
computer control, 4-5
CONFigure measurement instruction, 5-15
connector
care, 1-13
Cont key, 2-15, 3-10
CONT softkey, 2-29
CONTinuous programming command, 5-85
cotton swabs, 1-20
covers, dust, 8-15
cursor, 2-6
D
damaged shipment, 1-3
data corrupt or stale, 4-26, 5-8, 8-13
data questionable, 8-13
DATA? programming command, 5-27, 5-32,
5-46, 5-73
DBM softkey, 2-14
default GPIB address, 4-3
DELay? programming command, 5-25
Delta Off softkey.
See
Off
Delta On softkey.
See
On
DEVICES softkey, 2-10
DFB lasers, 2-10
dispersion.
See
calibration, measurements
display
annotation.
See
annotation
cursor, 2-6
modes, 2-3
resolution, 7-4, 7-7
scrolling through, 2-6
setting update rate, 2-14
softkeys blanked, 4-3
update rate, 2-14
DISPlay subsystem, 5-64
distortion, 2-8, 2-18
down-arrow softkey, 2-6
DRANge programming command, 5-34
DRIFT
annotation, 3-9
softkey, 3-10
drift, laser.
See
laser drift
dust caps, 1-21
dust covers, 8-15
E
E15 MAX NUMBER OF SIGNALS FOUND
message, 2-19
E46 NUM LINES < NUM REFS message, 3-10
E47 NUM LINES > NUM REFS message, 3-10
EDFA amplifier, 2-10
ELEV softkey, 1-10, 2-27
elevation
changing feet to meters, 1-10, 2-27
effects of, 2-26
entering, 1-10, 2-27
ELEVation programming command, 5-70, 5-71