Filter
Top Products
5-44
Programming Commands
CALCulate3 Subsystem
ASNR:CLEar
Clears the number of measurements used in the average signal-to-noise calcu-
lation.
Syntax
:CALCulate3:ASNR:CLEar
Attribute
Summary
Preset
State: not affected
*RST State: not affected
SCPI Compliance: instrument specific
Description
This command clears the number of measurements used in the average signal-
to-noise calculation. The current measurement is used as the new reference
for the average signal-to-noise calculation.
ASNR:COUNt
Sets the number of measurements to be used for the average signal-to-noise
calculation.
Syntax
:CALCulate3:ASNR:COUNt {?|{<integer> | MINimum | MAXimum }}
<integer> is a value that is within the following limits:
Constant
Description
MINimum 10
MAXimum 900
Attribute
Summary
Preset
State: 100
*RST State: 100
SCPI Compliance: instrument specific
Description
This command sets the number of measurements to be used for the average
signal-to-noise calculation. If this count is changed while the average signal
calculation is on, and the new count is less than the number of measurements
already taken, the instrument will go into single measurement mode.