Filter
Top Products
2-12
Using the Multi-Wavelength Meter
Displaying Wavelength and Power
Instrument states
Four different instrument states can be saved and recalled at a later time. The
actual instrument conditions that are saved are identical to those saved from
the previous state after power is turned on. These conditions are shown in
Table 8-1 on page 8-2. If drift measurements or an application (such as signal-
to-noise) is on when an instrument state is saved, it is off when that state is
recalled.
To save an instrument state
1
Press the
Setup
key.
2
Press the
SAV/RCL
softkey.
3
Press the
SAVE
softkey.
4
Press one of the four
SAVE
softkeys to save the instrument state.
To recall a state
1
Press the
Setup
key.
2
Press the
SAV/RCL s
oftkey.
3
Press the
RECALL
softkey.
4
Press one of the four
RCL
softkeys to recall an instrument state.
Power bar
To control the power bar
1
Press the
Setup
key.
2
Press
MORE
twice, and then
PWR BAR
.
3
Press
BAR ON
to display the power bar, and press
BAR OFF
to hide the power bar
display.