Filter
Top Products
5-53
Programming Commands
CALCulate3 Subsystem
DRIFt:DIFFerence[:STATe]
Sets the drift calculation to subtract the minimum values measured from the
maximum values measured.
Syntax
:CALCulate3:DRIFt:DIFFerence[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute
Summary
Preset
State: off
*RST State: off
SCPI Compliance: instrument specific
Description
Use the CALC3:DRIF:PRES command to turn off all the drift states before
turning on this state. The CALC3:DATA? query returns the maximum power
and frequency minus the minimum power and frequency.
Note
Only one STATe command can be turned on at any one time. Attempting to turn more
than one state on at a time results in a “–221 Settings Conflict” error. Refer to “Measure
delta, drift, and signal-to-noise” on page 4-14 for additional information on selecting
measurements.