Filter
Top Products
23
AutoMAtic repeAter oFFSet (k type only)
This function automatically selects an offset direction, according to
the frequency on the 2 m band. The transceiver is programmed for
offset directions as shown below. To obtain an up-to-date band plan
for repeater offset direction, contact your national Amateur Radio
association.
1
Enter Menu mode and access Menu No. 25 (ARO).
2
Press
[MENU]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
)
to select “ON”.
3
Press
[MENU]
to store the setting.
• You will be transmitting on an offset frequency value
determined from your offset setting value {page 20} and an
offset direction depending on your selected frequency. Refer
to the settings below for offset directions:
4
Press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
to exit
Menu mode.
Under 145.100 MHz: No offset (Simplex operation)
145.100 ~ 145.499 MHz: Minus (–) offset
145.500 ~ 145.999 MHz: No offset (Simplex operation)
146.000 ~ 146.399 MHz: Plus (+) offset
146.400 ~ 146.599 MHz: No offset (Simplex operation)
146.600 ~ 146.999 MHz: Minus (–) offset
147.000 ~ 147.399 MHz: Plus (+) offset
147.400 ~ 147.599 MHz: No offset (Simplex operation)
147.600 ~ 147.999 MHz: Minus (–) offset
148.000 MHz and higher: No offset (Simplex operation)