Filter
Top Products
39
5
Press
[F]
,
[MR]
then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select a channel from U0 ~ U2, corresponding to
the channel selected in step 4.
• For example, if you selected L0 in step 3, select U0 for the
end frequency.
6
Press
[MR]
to store the end frequency in the memory
channel.
■
Using Program Scan
1
Press
[VFO]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select a frequency within the frequency range of
memory channel L0/U0 ~ L2/U2.
2
Press
[VFO] (1s)
to start Program Scan.
3
To stop Program Scan, press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
.
Note:
◆
If you press
[MON]
, Program Scan temporarily pauses.
Release
[MON]
to resume scanning.
◆
The transceiver stops scanning when it detects a signal.
◆
If more than 2 Program Scan channel pairs are stored and
overlaps the frequency range among the pairs, the smaller
Program Scan memory channel number has priority.
◆
To perform Program Scan, the “L” channel must be lower than
the “U” channel.
memory sCaN
1
Press
[MR] (1s)
.
• Scan starts from the last memory channel number and
ascends up through the channel numbers (default).
• Rotate the
Selector
(or press
[UP]
/
[DOWN]
) to change the
scanning direction.