Filter
Top Products
51
• Press
[CALL]
to delete the character at the current cursor
position.
• On the transceiver display, DTMF code “
” is represented
by “E” and “#” is represented by “F”.
• You can also enter a DTMF code using the keypad.
Simply enter your desired DTMF codes on the keypad.
5
Press
[MENU]
to select the DTMF code and move the cursor
to the next digit.
6
Repeat steps 5 and 6 to enter up to 16 digits.
7
To complete the entry, press
[MENU]
without selecting a
DTMF code. To confirm the stored DTMF code, perform
steps 1 and 2, then press
[MON]
. The programmed DTMF
code scrolls through the display without transmitting.
8
Press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
to exit
Menu mode.
■
T
ransMiTTing a sToreD DTMF coDe
1
While pressing and holding
[PTT]
, press
[MENU]
.
2
Release
[MENU]
(continue pressing
[PTT]
), then rotate
the
Selector
(or press
[UP]
/
[DOWN]
) to select the desired
DTMF memory channel number.
3
While still holding
[PTT]
, press
[MENU]
again to transmit the
selected DTMF tones.
• The code stored in the channel scrolls across the display,
accompanied by DTMF tones from the speaker.
• After transmission, the frequency display is restored.
• If you do not need to confirm the memory channel
contents, press
[0]
~
[9]
instead of turning the
Selector
(or pressing
[UP]
/
[DOWN]
) in step 2, to select a channel
number. The stored DTMF code will be immediately
transmitted. (You do not have to press
[MENU]
in step 3.)