Filter
Top Products
37
seleCtiNg a sCaN resume method
The transceiver stops scanning at a frequency or Memory channel
on which a signal is detected. It then continues scanning according
to which resume mode you have selected. You can choose one of
the following modes. The default is Time-operated mode.
◆
Time-Operated mode (TO)
The transceiver remains on a busy frequency or Memory
channel for approximately 5 seconds, and then continues to
scan even if the signal is still present.
◆
Carrier-Operated mode (CO)
The transceiver remains on a busy frequency or Memory
channel until the signal drops out. There is a 2 second delay
between signal drop-out and scan resumption.
◆
Seek mode (SE)
The transceiver remains on a busy frequency or Memory channel
even after the signal drops out and does not automatically
resume scanning.
1
Enter Menu mode and access Menu No. 3 (SCAN).
2
Press
[MENU]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
)
to select a Scan Resume mode to “TO”, “CO” or “SE”.
3
Press
[MENU]
to store the setting.
4
Press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
to exit
Menu mode.
baNd sCaN
The transceiver scans the entire band of the frequency you
selected. For example, if you are operating and receiving at 144.525
MHz, it scans all the frequencies available for the 2 m band.
When the current VFO receive frequency is outside the Program
Scan frequency range {page 38}, the transceiver scans the entire
frequency range available for the current VFO.