Filter
Top Products
34
• When copying a transmit frequency from an odd-split Memory
or Call channel, you must first turn the Reverse function ON
before pressing
[F]
,
[VFO]
.
Call ChaNNel
The Call Channel can be recalled instantly no matter what
frequency the transceiver is operating on. For instance, you may
use the Call Channel as an emergency channel within your group.
In this case, Call Scan {page 40} will be useful.
The default Call Channel frequency is 144.000 MHz.
Note:
Unlike memory channels 0 to 99, the Call Channel cannot be
cleared.
reCalliNg the Call ChaNNel
Press
[CALL]
to recall the Call Channel.
• The Call Channel frequency and “C” appear.
• To return to the previous frequency, press
[CALL]
again.
reprogrammiNg the Call ChaNNel
1
Select your desired frequency and related data (Tone, CTCSS,
DCS, or offset direction, etc.).
• When you program the Call Channel as an odd-split channel,
select a reception frequency first.
2
Press
[F]
,
[CALL]
.
• The selected frequency and related data are stored in the
Call Channel.
To also store a separate transmit frequency, continue with the
following steps.
3
Select the desired transmission frequency.
4
Press
[F]
, then press
[PTT]
+
[CALL]
.