Filter
Top Products
30
To also store a transmit frequency, proceed to step 6; otherwise
proceed to step 10.
6
Press
[ ]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to
select the desired transmit frequency.
• The frequency selected in step 3 will be used as a receive
frequency.
7
Press
[ ]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to
select the memory channel that you selected in step 4.
8
Press
[F]
.
9
Press
[PTT]
+
[MR]
.
• The selected transmit frequency is stored in the memory
channel, and the memory channel number is incremented.
10
Repeat steps 3 to 5 (simplex) or 3 to 9 (split) to sequentially
store in memory channels.
• Turn the transceiver power OFF, then ON to exit Continuous
Memory Storage mode.
Note:
◆
If you use Direct Frequency Entry {page 13} to select a frequency
in step 2, you need not press
[ ]
.
◆
You cannot start Storage mode when in Channel Display mode.
◆
You cannot start Menu mode when in Memory Storage mode.
reCalliNg a memory ChaNNel
■
Using the Selector (or [UP]/ [DOWN] keys)
1
Press
[MR]
to enter Memory Recall Mode. The memory
channel last used is recalled.
2
Rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select your
desired memory channel.
• You cannot recall an empty memory channel.
• To restore VFO Mode, press
[VFO]
.
■
Using a Numeric Keypad
You can also recall a memory channel by entering a desired
memory channel number with the keypad.