Filter
Top Products
28
storiNg simplex frequeNCies or staNdard repeater
f
requeNCies
1
Press
[VFO]
, then rotate the
Selector
(or press
[UP
]/
[DOWN]
)
to select your desired frequency.
• You can also directly enter a desired frequency using the
keypad.
2
If storing a standard repeater frequency, select the following
data:
• Offset direction
• Tone function, if necessary
• CTCSS/ DCS function, if necessary
If storing a simplex frequency, you may select other related data
(CTCSS or DCS settings, etc.).
3
Press
[F]
,
[MR]
.
• A memory channel number appears and blinks.
• The “
” icon appears when the channel contains data.
• Memory channel number L0/U0 ~ L2/U2 {page 38} and Pr
(Priority Channel) {page 40} are reserved for other functions.
4
Rotate the
Selector
(or press
[UP
]/
[DOWN]
) to select the
memory channel in which you want to store the data.
5
Press
[MR]
to store the data to the channel.
storiNg odd-split repeater frequeNCies
Some repeaters use a pair of reception and transmission
frequencies with a non-standard offset. If you store two separate
frequencies in a memory channel, you can operate on those
repeaters without programming the offset frequency and direction.
1
Store the desired reception frequency and related data by
following the procedure given for simplex or standard repeater
frequencies.
2
Press
[VFO],
then rotate the
Selector
(or press
[UP
]/
[DOWN]
)
to select the desired transmission frequency.
3
Press
[F]
,
[MR],
then rotate the
Selector
(or press
[UP
]/
[DOWN]
)
to select the memory channel you programmed in step 1.