Filter
Top Products
58
3
Press
[MENU]
to store the setting.
4
Press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
to exit
Menu mode.
Frequency sTep size
Choosing the correct frequency step size is essential in order to
select your exact receive frequency using the
Selector
(or
[UP]
/
DOWN
). You can select your desired frequency step size from: 5,
6.25, 10, 12.5, 15, 20, 25, 30, 50, or 100 (kHz).
To change the frequency step size:
1
Press
[VFO]
, then press
[F]
,
[3]
.
• The current frequency step size appears.
2
Rotate the
Selector
(or press
[UP
]/
[DOWN]
) to select your
desired frequency step size.
3
Press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
to exit
the frequency step size selection.
Note:
If you change to a frequency step size that does not match the
current operating frequency, the transceiver automatically adjusts the
frequency to match the new frequency step size.
Back ligHT
To illuminate the display:
Press
[ ]
.
• If no other key is pressed, the light turns OFF approximately 5
seconds after releasing
[ ]
.
• Press any key (including
[PTT]
) other than
[ ]
while the display
is lit to restart the 5-second timer.
• Press
[ ]
while the display is lit to immediately turn the light
OFF.
To keep the light ON continuously: