Filter
Top Products
38
1
Press
[VFO]
.
2
Rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select the
frequency outside of the Program Scan frequency range.
3
Press
[VFO] (1s)
.
• Scan starts at the current frequency.
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, rotate the
Selector
clockwise
(or press
[UP]
) <upward scan> or counterclockwise (or press
[DOWN]
) <downward scan>.
4
To exit Band Scan, press any key other than
[MON]
,
[UP]
/
[DOWN]
or
[ ]
.
program sCaN
You can limit the scanning frequency range. There are 3 memory
channel pairs (L0/U0 ~ L2/U2) available for specifying the start and
end frequencies. Program Scan monitors the range between the
start and end frequencies that you have stored in these memory
channels. Before performing Program Scan, store the Program
Scan frequency range to one of the memory channel pairs (L0/U0 ~
L2/U2).
■
Storing a Program Scan Frequency Range
1
Press
[VFO]
, then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select your desired start frequency.
2
Press
[F]
,
[MR]
then rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select a memory channel from L0 ~ L2.
3
Press
[MR]
to store the start frequency in the memory
channel.
4
Rotate the
Selector
(or press
[UP]
/
[DOWN]
) to select your
desired end frequency.