Filter
Top Products
5. PARAMETERS
5 - 7
5.5 I/O setting parameters (No.PD
)
5.5.1 Parameter list
POINT
For details of the parameters in which columns MR-J3- B is written, refer to the
MR-J3-
B Servo Amplifier Instruction Manual section 5.4.
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
Never change the parameters for the manufacturer setting.
No. Symbol Name Initial value Unit Reference
PD01 For manufacturer setting 0000h
PD02 0000h
PD03 0020h
PD04 0021h
PD05 0000h
PD06
0000h
PD07 *D01 Output signal device selection 1(CN3-13) 0005h
PD08 *D02 Output signal device selection 2(CN3-9) 0004h
PD09 *D03 Output signal device selection 3(CN3-15) 0003h
MR-J3-
B
PD10 0000h
PD11 0004h
PD12 0000h
PD13
For manufacturer setting
0000h
PD14 *DOP3 Function selection D-3 0000h MR-J3- B
PD15 0000h
PD16 0000h
PD17 0000h
PD18 0000h
PD19 0000h
PD20 0000h
PD21 0000h
PD22 0000h
PD23 0000h
PD24 0000h
PD25 0000h
PD26 0000h
PD27 0000h
PD28 0000h
PD29 0000h
PD30 0000h
PD31 0000h
PD32
For manufacturer setting
0000h