Filter
Top Products
5. PARAMETERS
5 - 8
5.6 Special setting parameters (No.PS
)
5.6.1 Parameter list
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
** : Turn off the power and then on again after setting the parameter.
Never change the parameters for the manufacturer setting.
No. Symbol Name Initial value Unit Reference
PS01 **LIT1 Special function selection 1 0001h Section 5.6.2
PS02 For manufacturer setting 0000h
PS03
0000h
PS04 *LIT2 Special function selection 2 0003h Section 5.6.2
PS05 LB1 Servo control position deviation error detection level 9 0.01
rev
PS06 LB2 Servo control speed deviation error detection level 100 r/min
PS07 LB3 Servo control torque deviation error detection level 100
PS08 *LIT3 Special function selection 3 0010h
PS09 LPWM Magnetic pole detection voltage level 30
PS10 For manufacturer setting 0005h
PS11 0064h
PS12 01F4h
PS13 0000h
PS14 0000h
PS15 0000h
PS16
0000h
PS17 LTSTS Minute position detection method function selection 0000h Section 5.6.2
PS18 IDLV Minute position detection method identification signal amplitude 0
PS19 For manufacturer setting 0000h
PS20 0000h
PS21 0000h
PS22 0000h
PS23 0000h
PS24 0000h
PS25 0000h
PS26 0000h
PS27 0000h
PS28 0000h
PS29 0000h
PS30 0000h
PS31 0000h
PS32
0000h