Filter
Top Products
Paper Jams
23
Using
Remove paper jams by the following procedure when
copy paper does not come out of the output port or
when “” flashes on the Multi-Copy/Error Indicator.
1
Push down the printer open lever to open the
printer door.
2
Remove the thermal transfer film with both
hands.
3
Remove the jammed paper.
4
Install the thermal transfer film.
•Refer to steps 3 and 4 in the section of
“Installing the Thermal Transfer Film” on
page 18.
•“ ” flashing on the Multi-Copy/Error
Indicator will go out.
Note
•If “ ” is still flashing after closing the printer
door, make sure that the thermal transfer film
has been installed properly and tightened.
•The printer door should be closed to make
copies properly. Confirm both latches are
locked.
If the flashing “” does not go out after the foregoing
procedure has been performed; this may indicate that
the paper feeder is not functioning properly.
Reload the copy paper by following the steps given
below.
1
Turn the power off.
2
Open the paper cover and remove all the copy
paper remaining inside the unit’s paper cover.
Note
•The copy paper will slightly resist being
removed, but may be pulled out without
problems.
Paper Jams
J
ammed paper
ON
OFF