Filter
Top Products
For Your Safety
9
Before You Start
Stop operation immediately if your unit emits
smoke, excessive heat, abnormal smell or
unusual noise. These conditions can cause
fire or electric shock. Immediately turn the
unit off and unplug the power cord, and
contact your dealer for service.
When disconnecting the unit, grasp the plug
instead of the cord. Pulling on a cord forcibly
can damage it and cause fire or electric
shock.
The unit should be used only with the power
cord that is supplied by the manufacturer.
•(220–240 V equipment)
A certified power supply cord has to be
used with this equipment. The relevant
national installation and/or equipment
regulations shall be considered. A certified
power supply cord is not lighter than
ordinary polyvinyl chloride flexible cord
according to IEC 60227 (designation
H05VV-F 3G 1.0 mm
2
).
Installation and Relocation
To prevent fire or shock hazard, do not
expose this unit to rain or any type of
moisture.
Operating Safeguards
If metal fragments or water gets into the unit,
turn the unit off and unplug the unit
immediately. Contact your dealer for service.
Operating the contaminated unit can cause
fire or electric shock.
Never open or remove unit covers that are
screwed with screws unless specifically
instructed in the “Operating Instructions”. A
high-voltage component can cause electric
shock.
Do not alter the unit or modify any parts.
Alteration or modification can cause fire or
electric shock.
Keep the marker’s cap or battery out of
reach of children to prevent swallowing.
Battery
Be sure to use the specified type of batteries
only. Using incorrect type of batteries can
burn or leak.
Ensure that batteries are installed with
correct polarity. Incorrectly installed batteries
can burst or leak, resulting in spillage or
injuries.
Be sure to take out batteries worn away from
the unit. The battery worn away can leak.
Be sure that a battery should not be
charged, shorted, heated, broken or thrown
into fire. Using wrong can leak generate
heat or burst.
Power
When the unit is not used over an extended
period of time, switch it Off and unplug it. If
an unused unit is left connected to a power
source for a long period, degraded insulation
may cause electric shock, current leakage or
fire.
Installation and Relocation
Do not position the unit in a location where it
is unstable.
Do not place the unit in a hot humid or dusty
environment.
Prolonged exposure to these adverse
conditions may cause fire or electric shock.
When moving the unit, be sure to unplug the
power cord from the AC outlet. If the unit is
moved with the power cord attached, it can
cause damage to the cord which could result
in fire or electric shock.
CAUTION