Filter
Top Products
Using the Panaboard in Projector Mode
32
• When using a projector to project images, be sure to display the image so that it is centered left-to-right on the
Interactive Panaboard screen and with at least a 50 mm (2”) gap between the top of the image and the screen
border. Note that the Electronic Pen does not always operate properly when within 50 mm (2”) of the top of the
screen, 100 mm (3
15
/16”) of the position receiver and 35 mm (1
3
/8”) from the both sides of the screen.
• Since the Electronic Pen position may shift if the image on the screen is trapezoid, adjust the projector so that the
image on the screen is rectangular.
• When projecting an image on the Interactive Panaboard using a projector, the image on the screen may become
difficult to see depending on the viewing angle and position due to reflected projector light. If this happens, adjust
the location of the projector or change your viewing position.
• When using a projector to project a computer screen, be sure to use optimum resolution settings for the projector
and the computer. The image may be difficult to see if optimum settings are not used. Fine lines in the image on
the Interactive Panaboard screen may appear broken particularly if the projector resolution is lower than the
computer resolution.
• When using a projector to project images, the Electronic Pen position may shift if the projection position shifts due
to the following causes. If this happens, it becomes necessary to perform calibration to reposition the projected
image on the screen. (For details on calibration, see page 33.)
- When the installed location of the projector is changed.
- When the position of the Interactive Panaboard is changed.
- When the projection area and position has changed due to using a projector function such as zoom.
- When the display resolution of the projector or computer has changed.
Note that the position of an Interactive Panaboard attached to a stand may shift if it is struck carelessly.
Always make sure the stand's casters are locked in place.
• Light from the projector may enter the eye when using a projector to project images for the purpose of making
presentations and so on. Be very careful as direct projector light may hurt the eyes.
Using the Panaboard in Projector Mode
Precautions When Using a Projector
50 mm (2")
Position receiver
Position receiver
Interactive
upper limt mark
Interactive
upper limt mark
* Do not use the shaded area.
Screen film
100 mm (3
15
/16")
100 mm
(3
15
/16")
35 mm (1
3
/8")
35 mm
(1
3
/8")
Projector