Filter
Top Products
Using the Panaboard in Whiteboard Mode
50
Print out image automatically rotates to fit
printer paper direction setting is only related
to the Whiteboard mode.
Help Topics...:
Displays the help of the Interactive Panaboard
Software.
About...:
Displays the Interactive Panaboard Software
version information.
Exit:
Exits the Interactive Panaboard Software.
This section explains the basic operations when using
the Interactive Panaboard Software in the Whiteboard
mode. We recommend trying the operations in
accordance with the following steps to help you
completely understand the operations in the
Whiteboard mode.
Step 1: Drawing and erasing handwritten
lines on the Interactive
Panaboard screen
To start the Interactive Panaboard Software, see page 49.
1 If the Whiteboard window is not displayed,
right-click the icon in the Taskbar and
click Open Whiteboard Window.
2 Remove the cap of the Electronic Pen and
draw on the Interactive Panaboard screen
using the Electronic Pen.
•The position on the screen where you are
drawing will be reproduced on the page in
the Whiteboard window on the computer in
real-time.
3 Erase handwritten lines drawn on the
Interactive Panaboard screen using the
Electronic Eraser.
•Portions erased on the screen will also be
erased on the page in the Whiteboard
window.
•These drawing and erasing operations are
recorded automatically.
Note
•The following shows the writing area in the
Whiteboard mode. Do not write the shaded
area on the figure.
•Do not cover the position receiver with your
hand as this may cause interactive function
to stop functioning.
•Press down firmly with the point of the
Electronic Pen or the eraser on the screen
film until you hear a buzzing sound.
•Do not perform the following action near
(less than 1m) the Interactive Panaboard
while using the Whiteboard mode as this
may display unnecessary streaks not written
in the Whiteboard window.
- Exchanging markers for interactive (small)
of the Electronic Pen
- Setting or removing a marker cap of the
Electronic Pen
- Pushing the point of the Electronic Pen
•When exchanging markers for interactive
(small) of the Electronic Pen, lock the pen
holder lever while fully inserting the marker
into the pen holder until you hear a buzzing
sound. Detection of the marker color may not
work well unless the marker is inserted fully
into the pen holder. (Refer to “Setting the
Electronic Pen” on page 25.)
Basic Operation in
Whiteboard Mode
25 mm (1")
35 mm
(1
3
/8
")
35 mm
(1
3
/8
")
50 mm (2")
100 mm
(3
15
/16
")
Writing area
Writing area
Position receive
r