Filter
Top Products
Chapter 3 Installing and Configuring
17
Flexible Disk Drive
Use the following steps to install a flexible disk drive (FDD):
1. If the server is operating, log off all users, back up files, and power down the server.
2. Disconnect the power cord and any external cables connected to the server. If necessary, label each one
to expedite re-assembly.
3. Open the upper bezel and side panel.
4. Press the two latches of the drive inward and slide the drive out far enough to expose the connectors.
5. Disconnect the power and signal cable connectors.
6. Hold the disk by its sides and gently slide the disk from the chassis. See Figure 3-5.
Figure 3-5. Removing Flexible Disk Drive
7. Connect the power and signal cable to the new drive.
8. Gently slide the drive into the available opening until the eject mechanism clicks.
Watch the cable inside the side panel so it does not get pinched.
9. Close the upper bezel and side panel, and replace the external cables and power cord.
10. Power up the server and return it to normal operation.
CD-Rom or Optional Tape Disk Drive
Use the following steps to install a CD-ROM or optional tape disk drive:
1. If the server is operating, log off all users, back up files, and power down the server.
2. Disconnect the power cord and any external cables connected to the server. If necessary, label each one
to expedite re-assembly.
3. Open the upper bezel and side panel.
4. Disconnect the power and signal cable connector from inside the side panel.
5. Press the two latches of the drive inward and, holding the disk by its sides, gently slide the drive from
the chassis. See Figure 3-6.