Filter
Top Products
Chapter 3 Installing and Configuring
34
3. Read the documentation included with the accessory board and follow any special instructions. PCI
boards must be set to INT A on the board if jumpers are provided.
NOTE Adding a PCI-to-PCI bridge board to the HP Server may alter the server's boot order. This
boot order can be changed using the Setup Utility (press F2 during the boot process).
Refer to "Boot Priority" earlier in this chapter.
4. Open the side panel.
CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the chassis
when handling components. Ensure the metal of the wrist strap contacts your skin.
5. Remove any cables attached to the accessory board. If necessary, label each one to expedite re-
assembly.
6. Remove the IO locking bracket. See Figure 3-20.
a. Lift the bracket up.
b. Rotate it toward you and slide out.
Figure 3-20. Removing IO Locking Bracket
7. Identify the accessory slot number to be used. See Figure 3-21.