Filter
Top Products
19
Connection and Removal of FR-PU07BB
1.4.4 Connecting to FR-E700 using the connection cable (FR-CB2)
(1) Open the PU cover of the inverter.
(2) Insert one end of connection cable securely into the PU connector of the inverter and the other end into
the connection connector of FR-PU07BB along the cable guides until the stoppers are fixed.
(3) When using in the battery mode, turn ON the power supply switch of FR-PU07BB.
* A connection cable (FR-CB203 (wiring length is 3m)) is enclosed. The cable length when using a connection cable
other than the enclosed should be 3m maximum.
1.4.5 Removal when the connection cable (FR-CB2) is used
Hold down the tab (stopper) at the cable end and gently pull the plug.
CAUTION
· Connect the connection cable only when the front cover is installed.
· Do not subject the connection cables to scratches, excessive stress, heavy loads or pinching.
PU connector
Stopper
FR-PU07BB
STF FWD PU
Stopper
Connection cable (FR-CB2) *