Filter
Top Products
4. Carefully insert this end of the LC-LC cable into an SFP module that is installed
in the DS4700 Express. The cable connector is keyed to ensure it is inserted
into the SFP module correctly. Holding the connector, push in the cable until it
clicks into place, as shown in Figure 40.
5. Remove the two protective caps from the other end of the LC-LC cable. Save
the protective caps for future use.
6. Connect this end of the LC-LC cable to one of the following devices:
v An SFP module that is installed in a separate EXP810 or EXP710 storage
expansion enclosure or other DS4000 storage expansion enclosure
v An SFP module that is installed in a fibre channel switch port
v A fibre channel host bus adapter port
Protective cap
Fibre-optic
cable
Figure 39. Removing fiber-optic cable protective caps
Figure 40. Inserting an LC-LC fibre-channel cable into an SFP module
Chapter 3. Cabling the storage subsystem 63