Filter
Top Products
APPENDIX C
USING AEDIT
-86
ON
THE SERIES III
AEDIT-86
will
run on the Series III Microcomputer Development System under
the
ISIS/RUN
operating system.
c.
1 Invocation Command
The
invocation line
is
as described
in
Chapter
4.
If
you are not in
the
RUN
subsys-
tem,
the
invocation must be preceded by
RUN.
If
you are starting the tutorial in
Chapter
1,
type the following:
C.2 Terminals Used
with
the
Series
III
System
The
Series II I system may be connected to various terminals:
• Integrated Series III terminal
• Integrated Series
IIIE
terminal (with the
StllOC
firmware)
•
Other
terminals connected to the Series III via a serial channel
Descriptions
of
the Series III and Series
IIIE
follow
in
this appendix. See Appendix
F for working with other terminals.
C.3 Integrated Series
III
Terminal
C.3.1 Configuration Commands
The
hardware identification value
AH
is
S3 for the integrated Series III terminal.
This
is
the default hardware identification for AEDIT-86 if the system-id, as returned
by
UDI.
is
Series III. Configuration commands for the Series III terminal are
presented
in
Table 9-2.
C.3.2 Scrolling
Scrolling
at
the
main command level causes
the
message and prompt lines
to
disap-
pear. When scrolling
is
complete. the message and prompt lines are rewritten as soon
as a command (other than a cursor movement command)
is
typed. The integrated
Series III terminal has no reverse scrolling.
C.4 Integrated Series IIiE Terminal
The integrated Series
IIIE
terminal is an upgrade
of
the integrated Series III termi-
nal. An integrated Series III terminal may be upgraded to Series
IIIE
by installing
the
5tllOC
firmware. The integrated Series
IIIE
terminal has the following additional
features:
• Direct cursor addressing
• Additional output function codes (e.g., delete line. insert line)
• Fast block movement to the
CRT
C-l