Filter
Top Products
108 © 2014 Schneider Electric All Rights Reserved
Chapter 15—MID Compliance PowerLogic™ PM5300 series
Safety precautions
Installation, wiring, testing and service must be performed in accordance with all local
and national electrical codes.
1. Turn off all power supplying this device before working on it.
2. Always use a properly rated voltage sensing device to confirm that all power is off.
Installation and wiring
Refer to the installation sheet that shipped with your meter for meter installation and
wiring instructions.
Intended use
Indoor use only, permanently mounted in residential,
commercial or light industrial applications, where levels of
vibration and shock are of low significance
Mechanical environment M1
Electromagnetic (EMC) environment E2
Active Accuracy Class (kWh) C(kWh)
System types (for MID-compliant applications)
• 3-phase 4-wire Wye grounded
• 3-phase 3-wire Wye ungrounded
Voltage at voltage
terminals
3-phase 4-wire Wye
grounded
3 x 63.5(110) to 3 x 277(480) V AC
3-phase 3-wire Wye
ungrounded
3 x 110 to 3 x 480 V L-L
Current Rating (Imin – Iref (Imax)) 0.05-5(6) A
Electrical network frequency 50 Hz
Optical pulse output
(energy pulsing LED)
Location Meter front panel
Frequency 50 Hz maximum
Pulse constant
1
10,000 pulses per kWh
Wavelength 590 to 635 nm
Temperature Range -25
°C to +70°C
IP Rating IP51
Insulation Protective Class Class II
Impulse Voltage Rating 6kV
AC Voltage Rating 4kV
Main Cover Sealing Type Wire and Crimp
Intended Location of the Meter Indoor
1
See “MID-protected setup parameters” on page 110 for additional details.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical
work practices. See NFPA 70E in the USA or applicable local standards.
• Turn off all power supplying this device before working on it.
• Always use a properly rated voltage sensing device to confirm that all power is off.
• Do not exceed the device’s ratings for maximum limits.
• Do not use this device for critical control or protection applications where human or
equipment safety relies on the operation of the control circuit.
• Never short the secondary of a voltage transformer (VT).
• Never open circuit a current transformer (CT).
• Always use grounded external CTs for current inputs.
Failure to follow these instructions will result in death or serious injury.