A SERVICE OF

logo

Open as PDF
next previous
Chapter 4 85
Test Controller
User interface
• Selection 1 queries for the 40-bit address to read as follows:
Enter 40-bit address:
• Selection 2 queries for the 40-bit address and then for the 32-bits
of data to write:
Enter 32-bit data:
• Selection 3 queries for the 40-bit address to read.
• Selection 4 queries for the 40-bit address to write, and then for the
64-bits of data to write as follows:
Enter Upper 32-bits:
Enter Lower 32-bits:
• Selections 5 and 6 query for the 40-bit address for which to display
the ECC or tag of that memory line.
• Selection 7 queries the user for the test index with the following
prompt:
Enter test index [1-A]:
• Selection 8 prints information for the last HPMC that occurred on
the specified processor.
• Selection 9 clears all stored error information.
NOTE Use caution using selection 9 as there is no undo function.
• Selection A queries the user for the processor index as follows:
Enter cpu index [0-1f]:
• Selection B queries the user for the test index with the prompt
shown.
Enter test index [1-A]: