Chapter 4 93
Test Controller
Example of running diagnostics from Test Controller command line
Example of running diagnostics from
Test Controller command line
This example shows how to run mem3000 from the Test Controller
command line within the following scenario:
• Configure mem3000 to run on a system with four memory boards
installed.
• Set the classes and subtests to be executed.
• Run the tests.
• View the results.
Configuration
To execute the scenario, perform the procedures in this and the following
sections:
Step 1. From the Test Controller main menu shown below, select the Test
Selection Menu, option A:
Test Controller main menu
MAIN Menu commands
0=Quit Test Controller
1=Begin Test Controller Execution
2=Halt Test Controller Execution
3=Resume Test Controller Execution
4=Switch CPU
5=POST Boot Selection
6=Execution Mode Selection
7=Global Parameter Display
8=CPU Summary Display
9=Display CPU Errors
A=Test Selection Menu
B=Test Configuration Menu
C=Debugging Menu
D=Display revision
