106 Chapter 5
cxtest
Graphics interface
The selections presented are based on whether the Test Controller has
built a Subtest table and Class table in its tc_test_info_struct
structure.
Class menus
Selecting a test opens a window that displays all classes for the test. See
Figure 31. Down the left hand side of the window are a column of round
buttons, and down the right hand side of the window are two columns of
buttons.
Subtest menus
The left column of buttons allows the user to select all the subtests in the
class with a single click. The button will turn yellow when selected.
The round buttons on the right hand side select subtests (opening
another window for theses choices) within that class. If only some of the
subtests in a class are selected, then both the round buttons for that
class turn yellow.
Consider the round button on the left as an indication that tests within
the class have been selected and the round button on the right as an
indication that only some of the tests have been selected, as opposed to
all the tests of that class.
Figure 31 Test Class Selection menu
The last button on the right hand side associates parameters with the
test class. Clicking this button opens another window with the
parameters for that class. If there are more parameters than will fit on
the screen, a scroll bar allows the user to scroll the list.
Also above and below each of the scroll bars are two buttons that allow
the user to page up or down through the parameter list.
