Filter
Top Products
6-1
6. RADAR
This chapter provides the information necessary for radar operation.
6.1 How to Transmit, Set the Radar in Stand-by
Tap the [TX] icon at the bottom right corner of the screen to put the radar in transmit
or stand-by state. The icon is filled in white when the radar is in transmit state. (Trans-
mit, stand-by can also be controlled from the pop-up menu with [TX/STBY].)
If you do not require the radar for some time, set the radar in stand-by to save the mag-
netron from unnecessary use.
6.2 Tuning
By design the radar receiver is tuned automatically after the radar is set to transmit. If
you require fine tuning, do the following to tune manually:
1. Open the home screen, then tap [Settings] - [Radar].
2. The default tuning method is automatic. Turn off [Auto Tuning] to enable manual
tuning.
3. Drag the slider at [Manual Tuning] to set the value.
4. Tap the close button to finish.
TX/STBY switch
: Stand-by
: TX