Filter
Top Products
6. RADAR
6-14
6.13.2 How to activate or deactivate the guard zone
1. Tap on a line of the guard zone to show the pop-up menu.
2. Turn [Alarm] on or off. The alarm is active when the guard zone lines are solid and
the lines are dashed when the alarm is deactivated.
When a target enters an active zone, the aural alarm sounds (if active), the target
flashes, and the message "TARGET ALARM" flashes in the status bar. Tap the status
bar to silence the aural alarm and stop the flashing message. The message remains
in the status bar and the target continues to flash until the target leaves the guard zone
or the alarm is deactivated.
You can mute the audio alarm by turning off [Alarm Sound] in the [Settings] - [Alarm]
menu. (see paragraph 2.10.6).
6.13.3 How to hide the guard zone
Open the [Layers] menu and turn [Guard Zone 1] or [Guard Zone 2] off. The guard
zone is erased from the screen.
6.14 Watchman
The watchman feature transmits the radar for one minute at a specified time interval
(5, 10 or 20 minutes) to monitor the guard zone. If a target is found in the guard zone,
the watchman is canceled and the radar continues to transmit. This feature helps you
watch for targets in the area you set when you do not continuously require the radar.
1. Set a guard zone. See section 6.13. (Watchman does not operate unless a guard
zone is active. Set Watchman when the radar is in transmit state.)
2. Open the home screen, then tap [Settings] - [Radar].
3. Tap [Watchman].
4. Tap a watchman rest interval.
5. Tap the close button to finish.
6. On the radar display, tap the screen to show the pop-up menu. Turn [Watchman]
on to activate the watchman function.
1 min 1 min
TX TXST-BY ST-BY
Watchman starts
5, 10 or
20 min
5, 10 or
20 min