Filter
Top Products
2. PLOTTER
2-24
2.13 NAVpilot-700 Series Auto Pilot
This section shows you to how to enable use of the NAVpilot with your system. For
how to use the NAVpilot to steer to a point, see paragraph 4.12.4.
The FURUNO NAVpilot-700 Series Auto Pilot installs in the NavNet TZtouch2 network
to get automatic steering when going to a point or a route. The following NAVpilot func-
tions can be controlled from a NavNet TZtouch2 display:
• Control operation of the NAVpilot from this equipment.
• Select the NAVpilot steering mode (Auto or Nav).
Note: When an alarm message for the NAVpilot appears, check the control unit of the
NAVpilot.
2.13.1 How to enable use of the NAVpilot
Open the [Settings] - [Routes] menu, then turn on [Navigate with AutoPilot]. When you
set a route or point as destination, the message" Do you want to navigate using the
NAVpilot?" appears.
2.13.2 How to show the NAVpilot control box in the data area
1. Tap [DATA] or [ROUTE] on the data area to select where to show the NAVpilot-
control box.
2. Tap a data box or an unoccupied area to select where to show the NAVpilot con-
trol box. A pop-up menu appears.
3. Tap [NavPilot] to show the NAVpilot control box in the area selected.