Filter
Top Products
M440LX Server System Product Guide
113
▲
▲
!
VAROITUS
Paristo voi räjähtää, jos se on virheellisesti asennettu.
Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden
mukaisesti.
Replacing the Back-up Battery
See Figure 4-19.
1. Observe the warnings and cautions on page 3, “Safety Guidelines.”
2. Remove the left side cover (page 80).
3. Insert the tip of a small flat-bladed screw driver, or equivalent, under
the plastic tab on the snap-on plastic retainer. Gently lift up and pull
back on the retainer to remove it from the lithium battery socket.
4. Remove the battery from its socket.
5. Dispose of the lithium battery according to local ordinance.
6. Remove the new lithium battery from its package, and, being careful to
observe the correct polarity, insert it into the battery socket.
7. Install the snap-on plastic retainer on the socket.
8. Replace the left side cover (page 81).
9. Run the SCU to restore the configuration settings to the RTC. For
information about running this utility, see Chapter 3, “Configuring The
System.”