Filter
Top Products
178
Chapter 8 System Board Jumpers
Configuration Jumpers
The jumper is a small plastic-encased conductor (shorting plug) that slips
over two jumper pins. To change a jumper setting, use a jumper removal
tool, needle-nosed pliers, or your fingers to remove the jumper from its
current location. Position the jumper over the two pins for the desired
setting, and press it onto them. Be careful not to bend the pins.
The figure below shows the default jumper settings.
OM05777
PROT
CLR
PROT
CLR
NOR
RECVR
PROT
ENABLE
BOOT
OPT
PASS-
WORD
CMOS
CPU
SPEED
J2J1
Figure 8-1. System Board Jumpers