Filter
Top Products
154
Chapter 6 Server Resources
7. Gently push the plastic ejector levers (Figure 6-3) on the socket ends to
the upright position.
OM05273
Figure 6-3. Properly Seated DIMM
8. Repeat the above steps to install more DIMMs. Always install them in
sequence by installing the next DIMM in bank 1, socket J2, and so on
with the last one in bank 7, socket J8.
9. Install the memory module and the left side cover as described in
Chapter 4, "Working Inside Your System."
10. Connect all external cables and the power cord(s) to the system.
11. Turn on the monitor and then the system.
12. Run the System Configuration Utility (SCU) to configure the system and
to properly attribute ECC memory. Failure to do so may degrade the
performance of your system. For information about running the SCU,
see Chapter 3, "Configuring The System."