Filter
Top Products
M440LX Server System Product Guide
89
OM05773A
A B C
Figure 4-5. Removing a Termination Board
A Latch
B Terminator Latching Assembly
C Terminator Board
Installing a Voltage Regulator Module
See Figure 4-6.
1. Observe the warnings and cautions on page 3, “Safety Guidelines.”
2. Remove the left side cover (page 80).
3. Being careful not to touch the components or connector on the voltage
regulator module, remove it from its protective wrapper and place it on
a nonconductive, static-free surface.
4. Record the module ID information (may be a date code) in your
equipment log.
5. Hold the module by its top edge or upper corners and firmly press it
into the connector (Figure 4-6) on the system board until the lock tabs
click into place.