Filter
Top Products
M440LX Server System Product Guide
211
Hard Disk Drive Activity Light Does Not Light
If you have installed one or more hard disk drives in your system, check the
following:
❑ Are the power and signal cables to the hard disk drive properly
installed?
❑ If your system contains a SCSI host adapter controller board, is it fully
seated in the system board connector?
❑ Are all relevant switches and jumpers on the hard disk drive and
controller board set correctly?
❑ Is the onboard IDE controller enabled?
✏
Note
The hard disk drive activity light on the front panel lights
when either an IDE hard disk drive or SCSI device is in use.
❑ Is the hard disk drive properly configured?
❑ If your system contains a SCSI host adapter controller board, is the hard
disk activity LED cable connector plugged into the controller board and
the system board?
If you received error messages, refer to "Error and Informational Messages"
on page 213 for information about error messages.
If you did not receive error messages, run the SCU and make sure that the
hard disk drive is configured with the correct parameters. For information
about running the SCU, see Chapter 3, "Configuring The System."
If the problem persists, there may be a problem with the hard disk drive, the
add-in controller board, system board, drive signal cable, or LED connector.
Contact your service representative or authorized dealer for assistance.