Filter
Top Products
M440LX Server System Product Guide
129
Installing the Power Share Backplane
See Figures 4-26 and 4-27.
1. Observe the warnings and cautions on page 3, “Safety Guidelines.”
2. Remove the right side cover (page 80).
3. Position the mounting holes in the power share backplane over the
snap-in standoffs and threaded standoffs on the inside chassis wall.
4. Push the backplane toward the chassis wall until it snaps onto the
snap-in standoffs.
5. Insert the screws through the mounting holes in the backplane and into
the threaded stand-offs on the inside chassis wall; tighten the screws
firmly (6.0 inch-pounds).
6. Replace the power supplies.
7. Connect the power and signal cables to the power share backplane.
8. Replace the side cover (page 80).