Filter
Top Products
52
Chapter 3 Configuring The System
How to start the SCU
Before you can run the SCU from a diskette, you must copy the SCU from
the Configuration Software CD to a DOS bootable diskette. For instructions
on creating an SCU diskette, see Chapter 2, “Installing The System.”
1. Turn on the video display monitor and system.
2. There are three ways to start the SCU.
• After creating an SCU diskette from the CD: Insert the
System Configuration Utility Disk in drive A, and press the
reset push-button switch or <Ctrl+Alt+Del> to reboot the
system from the diskette.
• After installing the operating system: Insert the System
Configuration Utility Disk in drive A, and copy it to a
directory on the hard drive. While in the directory, type
AMISCU
and press <Enter>.
• From diskette after installing the operating system: Insert
the System Configuration Utility Disk in drive A. At the
MS-DOS
†
prompt, type
a:
and press <Enter> to change to
drive A. Type
AMISCU
and press <Enter> to start the SCU.
When you see this message:
MS-DOS Startup Menu
-------------------------------
1. Execute AMISCU
2. Execute AMISCU for system with PNP OS
If the operating system in the system supports Plug and Play add-in
boards, press <2> to start the SCU. If not, press <1> to start it.
3. When the SCU title appears on the screen, press <Enter> to continue.
4. From the main menu, press <
↑
> or <
↓
> to highlight an item and then
press <Enter> to select it. If you are using a mouse, point to an item and
double-click the left button to select it. Press <F1> at any time for help
about a selection.
5. For information about setting up the system select “Step 1: About
System Configuration” from the main menu.